- #IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 INSTALL#
- #IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 UPGRADE#
- #IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 FULL#
- #IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 MAC#
Old tape was easily using finger nails, since screen was still connected at the bottom. (I taped SATA connecter as well so drive wont fall off due to heating etc. There is enough space for 7mm thick SSD+ old cable and it wont hit LCD if you secure them with duct tape and leave it there.
After making sure everything worked, had no fan problem etc, I glued it back gently and tapped upper two corners of the screen for safety, which remained there few days.ġ. I did not glued back right away until I installed new os using a bootable OS USB.
#IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 INSTALL#
(I used 2tb SSD, so it could be partitioned to install two operating systems later on). I did'nt had to remove any LCD cables or screws from old drive.
#IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 MAC#
Before prying, my Mac was laid flat on it's back (horizontally on a quilt with books/pillows etc) as I do think prying in a vertical position is dangerous.īased on reviewer's experiences whose screen fell-off or bottom of the screen was hard to remove, I pried-off screen (using supplied plastic tool) three sides only, gently lifting less than 1/16" at a time, equally at all three sides (top, left and right) and finally lifted it about 3"-4" high from top only, so I could pull out existing SATA cable from HDD end only and then placed and re-connected a brand new, pre-formatted (osx extended) 2tb SSD on top of existing old drive, which remained inside. Before buying, make sure that you are ordering the right size and everything is ready. This 15.99$ LeFix 27" kit worked for a 27" i-Mac (late 2015, retina 5k).
#IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 UPGRADE#
Adhesive strips must be replaced every time after the display is removed for repair or upgrade purposes, these are the highest quality adhesive stickers available but they require 100% correct installation upon perfectly clean parts that have no trace of dirt/ dust or the previous adhesive tapes for maximum contact heat the adhesive with hair dryer before applying. After the adhesive is cut, it cannot be used to re-seal the display in place, so you'll need to apply a new set of adhesive strips. If you are not sure whether it is the correct item you need, please contact us with specific model and pictures of your original screen.Why Need to Buy This Item Removing the display requires cutting through the adhesive around the perimeter of the screen. Please kindly check your model and resolution again before you purchase.
#IMAC 27 LATE 2013 GLASS REPLACEMENT EMC 2639 FULL#
If you miss this, your system fan would be running at full speed at all times. DONT forget to transfer the thermal sensor. You have to remove those from the old screen and put them in on the new one. This is a replacement screen and it doesn't come with the data cable and the thermal sensor.
0 kommentar(er)
